Quarterly Activities and Cashflow Report
Melbourne, Oct 31, 2016 AEST (ABN Newswire) - Indago Energy Ltd (
ASX:INK) (POGLY:OTCMKTS) is pleased to provide the company's Quarterly Activities and Cashflow Report for the period ended 30th September 2016.
Summary
- Cash position at September 30th of A$4.4m
- Company enters into MOU for the acquisition of Hydrocarbon Dynamics
- Newkirk asset in Oklahoma maintained
Financial
At September 30th, Indago Energy had cash resources of $4.4 million compared with cash reserves of $4.9 million at the end of June. The reduction in cash from the previous quarter included a once off payment for a redundancy associated with the previous management of $182,000 which was foreshadowed in the June quarter 5B.
Newkirk Project, Kay County Oklahoma (100% WI 81.25%NRI)
Indago holds a 100% WI and 81.25% NRI in 4,049 acres located in Kay County, Oklahoma near Ponca City. The leases were largely acquired during 2015 with a three year primary term and two year bonus term. The project is located within the Mississippi Lime tight oil play, a relatively mature play in which hundreds of wells have been drilled in the past decade (see Figure 1 in the link below).
After a detailed review of the project was completed in the prior quarter, the board decided to maintain the asset and would look to appraise it with Indago's joint venture partner and Operator, Empire Energy Limited (ASX:EEG):
As reported previously, the main target Mississippian Lime (MSSP) is a carbonate formation which underlies a large portion of northern Oklahoma and southern Kansas. The play lies at shallow depth of 1200-2200m (4000-7000') and is about 100m (300') thick. Oil & gas is sourced from the underlying, highly prolific Woodford shale.
Reservoirs comprise the upper 'Chat' and lower 'Solid' members. The Chat is 12-15m (40-50') thick and is typically high porosity with variable permeability. The underlying Solid displays low porosity with local higher porosity 'sweet spots'.
Both MSSP reservoirs have been the focus of drilling and fracture simulated completions employing vertical wells since the 1940's and horizontals since 2007. Initial flow rates for vertical wells average ~45 stb/d oil and ~80 Mscf/d gas. For horizontals, initial flow rates are highly variable dependant on how many 'sweet spots' are encountered. Wells produce significant salt water with low oil cuts, typically 10:1. Consequently, salt water disposal/injection (SWD) is an important consideration at the Newkirk Project.
Vertical well recoverable reserves are expected to average ~30 Mstb oil and 200 MMscf gas. Estimated vertical well drill and completion cost is US$0.5m and for SWD wells is expected to be US$0.75m. One SWD well is required for every 10-12 vertical oil producers.
The prospectivity review concluded that Indago's leases are prospective for oil and gas but given the paucity of modern wells in the immediate vicinity of Newkirk, the project should be appraised with 2-4 wells prior to development. Should the appraisal programme confirm typical play production and recovery characteristics, the project would present an attractive development when US domestic oil prices approach US$60/bbl.
Given the improvement in oil prices, the JV is seeking an update on well costs and a review of well economics with a view to testing the play in the first quarter of next year. It should be noted that some of Indago's leases begin to expire in 2017.
Oil and gas leases held by Indago are contiguous with an additional 4,936 acres held by EEG. Under a Joint Operating Agreement, the two companies have agreed to the further development of the combined acreage (8,985 acres) on a 50/50 basis.
Corporate
As announced to the ASX on October 28, 2016, Indago Energy has signed a Memorandum of Understanding ("MOU") to acquire the Hong Kong based HCD Holdings Ltd, its related companies and associated Intellectual Property (collectively "the Companies"). Details of the Companies are contained at www.hydrocarbondynamics.com. Together the Companies own a revolutionary new oil technology and business that allows for the swift, clean and cost effective treatment of heavy asphaltenic and paraffinic oils.
The technology can be applied to improve oil flow rates by the re-liquification of oil deposition from oil wells and pipelines and can also be used to recover oil from storage facilities. The product has proved its effectiveness in large-scale commercial oil wells and pipelines in Malaysia and India.
The key product, HCD MultiflowTM is a small, specially engineered carbon-based organic molecule that can disaggregate the large, naturally occurring agglomerations of waxes and asphaltenes in heavy or paraffinic oil. Once disaggregated, these agglomerations are reabsorbed into the crude oil, reducing its pour point, viscosity and increasing API gravity thus providing outstanding flow assurance and transfer system efficiency. The HCD MultiflowTM molecule can also separate water and sediment from the crude oil and the product will have far-reaching applications in the productibility and transport of heavy/paraffinic crudes, as already evidenced by the product's use in a large offshore oil field and with many successful trials to its credit.
Key product applications identified and substantiated by successful trials include:
- flow assurance in onshore/offshore pipeline and oil gathering lines that transport heavy or paraffinic crudes;
- flow assurance in the down-hole and near well bore reservoir interface in reservoirs that produce heavy or paraffinic crudes (supported by a companion product, a paraffin consuming faculitive bacterial brew for treatment down hole);
- efficient clean-up, oil recovery and water and sediment separation of tank bottom sludge in oil tank batteries offshore/onshore;
- efficient clean-up, oil recovery and sediment separation in remediation of hydrocarbon contamination sites and potential application to hydrocarbon recovery in tar sands.
HCD MultiflowTM competes directly with and outperforms chemical polymers and toxic solvents (Benzene-Toluene-Xylene) currently utilised to combat paraffin/asphaltene deposition in pipelines, gathering lines and down-hole production tubulars. Key technical advantages that HCD MultiflowTM possesses over its competitors are:
1) efficacy over a much broader application range;
2) immunity to loss in the water phase of produced fluids;
3) much higher "flash point" than typical chemicals used in the industry;
4) advantage of not reducing the products effectiveness when transported through system pumps (Polymer chemistry typicaly shears when agitated by the pump impeller blades greatly reducing the effectiveness of the chemical product);
5) it is non-toxic making it environmentally friendly as well as much safer to handle;
6) HCD MultiflowTM is much less expensive than its competitors in a cost per barrel of oil comparison;
7) Direct Refinery Feed - no re-treatment of crude required before Refining stage.
The technology is proven, however is at an early stage of application in the industry with current revenues of around A$1.2m. HCD MultiflowTM is currently being used by Malaysia's national oil company, Petronas, on a major offshore platform and pipeline system as well as in India with excellent reproducible results. Indago will use its technical, financial and commercial resources to expand the technology rapidly. Indago will also look to acquire existing oil accumulations where the technology will be used to increase or commence oil production. Many of the world's oil provinces produce waxy or heavy crudes and experience associated production and transport problems and will represent early targets for the growth in both oil production and technology sales.
The parties will commence a period of due diligence while a comprehensive share purchase agreement, royalty agreement and other documentation are entered into. There are a range of conditions precedent in the MOU including, due diligence, respective shareholder approvals at both the Indago and HCD levels, definitive documentation and regulatory approval. Indago therefore cautions that there remains a risk that the transaction will not be completed.
In a staged transaction and subject to the various conditions, Indago will initially pay ~A$1m in cash or assumed liabilities plus 50m fully paid shares and 33.2 million options (exercisable at $0.25c for two years). To secure ownership of the Intellectual Property Indago will also pay a royalty of 5% of net sales to inventor Nick Castellano until those payments total US$20m. The royalty is also subject to a US$20,000/month minimum.
Two performance payments may be earned as follows: Up to an additional 30m Ordinary Shares may be payable upon the HCD business achieving an EBITDA of $USD 4 million for a twelve month period closing March 31, 2018 with 10 shares deducted per $1 of EBITDA below USD 4 million. No shares will issued if EBITDA is below USD 1 million (Performance Milestone Tranche 1), and; up to an additional 50m Ordinary Shares payable upon the HCD business achieving an agreed EBITDA of USD8 million for the twelve month period ending March 31st , 2019 with 10 shares deducted per $1 of EBITDA below USD 8 million and no shares issued if EBITDA is below $3m (Performance Milestone Tranche 2).
In addition Indago has also agreed finance approximately US$400,000 worth of product for HCD (prior to completion of the proposed transaction) to sell to existing customers to enable the Companies to finance product orders. Indago shareholders will however receive the sale proceeds from this product whether or not the merger completes.
Three representatives from HCD will, subject to shareholder approval, join the INK board and will include the founder and inventor of the technology, Nick Castellano, along with HCD's Managing Director Allan Ritchie. Both will fulfil Executive Director roles.
To view the report, please visit:
http://abnnewswire.net/lnk/IV798SJT
About Indago Energy Ltd
Indago Energy Ltd (ASX:INK) (OTCMKTS:POGLY) is an Australian listed company engaged in oil and gas exploration, development and production. Indago's project portfolio includes liquid rich producing assets together with substantial oil development and exploration acreage in the United States.
The Company's Exploration and Production focus is on high growth oil and gas projects offering scalability of production, cash flows and reserves. Indago currently has several producing projects together with a significant acreage position. The Company's immediate focus is the development of its Capitola Oil Project located in an active region of the Cline Shale resource play along the Eastern Shelf of the Permian Basin, Texas. The project's core development and exploitation opportunities are shallower multiple "stacked" sandstones and limestones to depths of 7,000 feet which are effectively produced from vertically drilled wells. Indago's value driven model is executed through exploiting shallower, well defined intervals with advanced completion and stimulation technology within known produced oil fields together with exposure to the emerging Cline Shale resource play.
Indago's shares are publicly traded on the Australian Securities Exchange (ASX ticker: INK) and also as American Depositary Receipts on the OTCQX (ADR ticker: POGLY).
| ||
|
